Tag Archives: sealer repair

We created this troubleshooting guide to help with our most frequently asked questions regarding sealers.

Impulse sealers (hand, foot, automatic) work in a similar manner – often, if you are having a problem with your sealer, the solution can be found in the following parts:  heating element, PTFE adhesive, PTFE cover, microswitch, mounting spring, and/or timer.  Let us know if you have a problem that isn’t listed in this guide and we can try and assist you.

1. Check element and PTFE cover and adhesive.
   • Element: This is the wire (flat or round) that heats up to seal or cut the bag/film. Remove the PTFE cover and check that the wire is not discolored, bent, or broken.
   • PTFE Adhesive: This is the 1/2″ piece with an adhesive backing UNDER the heating element.  It should extend past the seal area 1/2″ on either side because it is the barrier between the metal machine and the metal heating element. For the PTFE adhesive, you must replace the bottom sealing strip whenever you change the element.  The adhesive serves as a barrier between the heating element and the sealer’s body.  When the sealer’s heating element has burned through the bottom adhesive and arc’ed on the sealer’s body, the element will break as well as destroy the timer.
   • PTFE Cover: The PTFE cover that goes over the heating element must be whole to prevent the plastic bags or film from sticking to the element. For the teflon cover, we recommend changing the cover BEFORE it burns through.  As the cover wears, you will see a discoloration where it comes into contact with the element, you may also notice that your element is sticking to the thermoplastic material you are sealing.  You can maneuver the cover back and forth to allow the element to come into contact with the unused portions of the PTFE cover. If you are sealing/cutting a thicker plastic material (higher amount of heat) you may go through a lot of PTFE covers.
   • We highly recommend having these parts in stock since they do wear and tear.  To purchase a replacement part which would include all three items, visit our site here.
2. Listen for “click” from microswitch when pushing bar down. This click should occur right before the upper bar comes into contact with the lower. If there is no click try the following:
   • Hand Sealer: Slightly bend metal switch lever so that when arm of sealer is brought down, the lever makes contact with microswitch and a click can be heard.
   • Foot Sealer: Small bolt for limit switch must be tightened as needed to make contact with the microswitch.
   • Auto Sealers: A 3.5″ screw that is mounted on upper jaw must be loosened so that it will make contact with microswitch which is mounted on left side of hinge bracket.
   • Microswitches can be purchased here on our site.
3. Mounting Spring: Make sure that the spring the element mounts on is intact. Replace if damaged.  Please check also that the mounting spring is not rusted or worn in any way as this will prevent the element from conducting heat.  Mounting springs can be purchased here.
4. Timer Light: The light on the timer should come on briefly when the seal bar is brought down for sealing. If it does not come on, the timer PC board probably needs replacing.  Timers can be purchased here, but contact us if you cannot find the timer you are looking for.